| Customization: | Available |
|---|---|
| After-sales Service: | Yes |
| Warranty: | 2 Years |
|
Still deciding? Get samples of US$ 34.3/Piece
Order Sample
|
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
ADL200 DIN Rail AC Energy Electric Meter with Modbus
ADL200 single-phase electronic watt-hour meter is mainly used to measure single-phase active energy in low-voltage networks. It can also measure voltage, current, power and other electricity. It is equipped with standard RS485 communication function, which is convenient for users to monitor, collect and manage electricity consumption.
It can be flexibly installed in the distribution box to realize the sub-item electric energy measurement, statistics and analysis of different areas and different loads.
Accuracy kWh:Class 1
Frequency:45~65Hz
Communication:RS485(MODBUS-RTU)
Power Supply:154~264Vac
Pulse output:kWh
|
|
|
|
|
| DC Energy Meter | WIFI Meter | Three-phase Power Meter | Single-phase Power Meter | 1P Single Phase Meter |
Q: The power or energy count is inaccurate after the meter is powered on.
A: Switch the meter display to the power (active power P, power factor λ) interface, and check whether the power display is negative or not. And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current incoming wire must be the same as the incoming wire end of the instrument) and consistent with the wiring diagram on the instrument.
Q: The instrument cannot communicate with the host computer usually after powering on.
A:1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V;
2. Check whether the communication wiring method is correctly wired in accordance with the wiring diagram requirements (that is, the communication terminal A/B of the corresponding to communication serial port A/B)
){kind=link}