| Customization: | Available |
|---|---|
| After-sales Service: | Yes |
| Warranty: | 1 Years |
|
Still deciding? Get samples of $ !
Order Sample
|
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Acrel ADL400 three phase din rail energy meter is an intelligent instrument designed mainly for electric energy statistics and management needs of power systems, industrial and mining enterprises, and public facilities. The product has the advantages of high precision, small size, and convenient installation. It can measure all power parameters, with 2~31 sub-harmonic and total harmonic content detection. With RS485 communication interface and optional MODBUS-RTU protocol, the power meter can be widely used in various control systems, SCADA systems, and energy management systems.
Rated Current: 1 (6) A, 10 (80) A
Rated Voltage: AC220V/380V, AC230V/400V
RS485(MODBUS-RTU) Communication
12 digits LCD Display; 35mm DIN Rail Installation
Multi-tariff: 4 Tariff Rates (Spike, Peak, Valley and Flat kWh)
2~31st Harmonic Measurement
MID Certified
Set parameters
kWh Class 0.5S
| Voltage | Rated voltage | AC 220V | |
| Rated frequency | 50Hz | ||
| Consumption | <10VA | ||
| Current | Maximum current | 80A | |
| Starting current | 0.01A | ||
| Consumption | <1VA | ||
| Measurement performance | Accuracy | kWh Class 0.5 | |
| Range | 0~9999999999.99kWh | ||
| Clock | Accuracy | Error ≤0.5s/d | |
| Active pulse | Width | 80±20ms | |
| Constant | 1000imp/kWh,10000imp/kWh | ||
| Communication | Interface | RS485 | |
| Protocol | Mod bus-RTU | ||
| Temperature range | Work | -25ºC~55ºC | |
| Storage | -40ºC~70ºC | ||
| Humidity | ≤95%(No condensation) | ||
| Altitude | <2000m | ||
FAQ
Q:After the meter is powered on, the power or energy count is inaccurate.
A:Switch the meter display to the power (active power P, power factor λ) interface, and check whether the power display is negative or not. And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current The incoming wire must be the same as the incoming wire end of the instrument) and consistent with the wiring diagram on the instrument.
Q:The instrument cannot communicate with the host computer normally after power on.
A:1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V;
2. Check whether the communication wiring method is correctly wired in accordance with the wiring diagram requirements (that is, the communication terminal A/B of the corresponding to communication serial port A/B);
){kind=link}