| Customization: | Available |
|---|---|
| Type: | Distribution Metering Box |
| Structure: | Protection |
|
Still deciding? Get samples of $ !
Order Sample
|
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
ADL200 Single Phase Energy Meter RS485 Modbus-RTU with MID Certification
Single-phase ADL200 & Three-phase ADL400 energy meter adopts DIN35mm din rail installation with LCD display, it can measure electric parameters and energy pulse output, RS485 communication, which has the advantages of small size, high precision, good reliability, and convenient installation.
| Voltage | Rated voltage | AC 220V | ||
| Rated frequency | 50Hz | |||
| Consumption | <10VA | |||
| Current | Maximum current | 80A | ||
| Starting current | 0.01A | |||
| Consumption | <1VA | |||
| Measurement performance | Accurary | kWh Class 0.5 | ||
| Range | 0-99999999kwh | |||
| Clock | Accurary | Error≤0.5s/d | ||
| Active pulse | Width | 80±20ms | ||
| Constant | 1000imp/kWh,10000imp/kWh | |||
| Communication | Interface | RS485 | ||
| Protocol | Modbus-RTU | |||
| Temperature range | Work | -25ºC-55ºC | ||
| Storage | -40ºC-70ºC | |||
| Humidity | ≤95%(No condensation) | |||
| Altitude | <2000m | |||
Single-phase Power Meter ADL200
Three-phase Power Meter ADL400
3/10(80)A Current Input Directly
3*1(6)A Current Input via CT
|
|
|
|
| ADW210 Energy Meter with RJ12 Split-core CT | AWT100 Smart Gateway | ADW300 WIFI Meter | ADF400L Multi-circuit Power Meter |
Q: The power or energy count is inaccurate after the meter is powered on.
A: Switch the meter display to the power (active power P, power factor λ) interface, and check whether the power display is negative or not. And whether the power factor is between 0.9-0.95, and then check whether the incoming and outgoing wires of the current signal wire are connected reversely (that is, the current incoming wire must be the same as the incoming wire end of the instrument) and consistent with the wiring diagram on the instrument.
Q: The instrument cannot communicate with the host computer usually after powering on.
A:1. The voltage value between the communication output A and B of the measuring instrument should be between +(4.4-4.5)V;
2. Check whether the communication wiring method is correctly wired in accordance with the wiring diagram requirements (that is, the communication terminal A/B of the corresponding to communication serial port A/B)
|
|
| MID | CE |
){kind=link}